Set of 12 laser cut green acrylic windows for Star Trek The Next Generations's Borg ship
For use in the Borg ship in Star Trek the Next Generation, Williams #A-17756
These thicker acrylic windows will not tear or curl like the original acetate film pieces
To install, remove your old acetate windows and clip off the heat stakes. Next, place all the parts into the ship to get the proper idea as to how they fit. If there is a fit probem, use a Dremel or small file to trim the acrylic.
Next, put silicone glue or hot glue on blank areas around the windows of the Borg ship and press the appropriate windows into place. (Be careful not to apply to much glue) Do not glue all of the pieces at once and take care to keep the glue away from the edges of the Borg ship windows.
If your ship is melted the front (the smaller L shaped part is the most commonly melted area), glue the long acrylic window first. Once this piece has set (dried) glue and set the shorter window
